Setting Up QPST for file transfers

Enabling file transfers with QPST

The following seem needs to be edited with p2k seem editor:

Enable QPST File Transfer			WORKS
2742	Bytes: 0000	Offset: 5a	Check Bit 7
Allows you to transfer files using the QPST EFS explorer.

(do not have MSU or PST running with this application - it does everything for you)

FIRST you must obtain the QPST (oops) program. After downloading it, then double click on it, click the "install" button, then after it extracts, double click on the actual QPST installer program within the folder. Once it's done then proceed.
Connect the phone to the PC with the mini USB cable
Open the QPST configuration utility
Make sure you are on the "Ports" tab
Ensure that the ports are enabled by clicking the "Enable" button
If after waiting a bit, it still says "no phone", click the "Add New Port" button
Choose port(s) from the list on the left, click OK
Momentarily, the phone should be recognized and appear as "SURF6500-ZRF6500"
Click on the "Start Clients" menu
Choose "EFS EXPLORER"
Make sure the SPC field is set to 000000
Click OK and let it connect - leave the configuration utility running
This can be an alternative to using either P2K Commander (under RSD CDMA General) or Bitpim at times for file transfers between your computer and your phone. HOWEVER, QPST sometimes will not allow certain transfers (i.e. will give you a brew 'locked' message) but your mileage may vary.